YG-1 E5058 Carbide Square Nose End Mill, Uncoated (Bright) Finish, 40 Deg Helix, 6 Flutes, 3.5' Overall Length, 0.625' Cutting Diameter, 0.625' Shank Diameter: Home Improvement. YG-1 E5058 Carbide Square Nose End Mill, Uncoated (Bright) Finish, 40 Deg Helix, 6 Flutes, 3.5" Overall Length, 0.625" Cutting Diameter, 0.625" Shank Diameter: Home Improvement. Suitable for finishing on most materials . Six flutes produce a better finish than fewer flutes . 40-degree helix provides increased cutting action compared to end mills with lower helix angles . Carbide can run at higher speeds than high-speed or cobalt steel, resisting wear and high cutting temperatures . Uncoated (bright) tools have no additional surface treatment or coating for use on a broad range of materials . The E5058 uncoated carbide square nose end mill has six flutes, a 40-degree helix angle, and a center-cutting design for finishing on most materials. Six flutes produce a better finish than fewer flutes. The 40-degree helix angle offers increased cutting action compared to end mills with lower helix angles, as it moves excess material quickly up the spiral and away from the workpiece. The tool’s square end creates sharp, unrounded cuts. The center-cutting design has cutting teeth at the end of the tool, so it can be fed into the workpiece like a drill bit. . Carbide is harder than high-speed or cobalt steel, making it more wear resistant at high speeds and providing longer tool life. With no coating or surface treatment, this uncoated tool can be used on a broad range of materials. Cutting diameter tolerance is + 0.0000 to - 0.0012". The round shank accommodates a range of tool holders. . End mills are designed to remove material and create multi-dimensional shapes and profiles. They have cutting edges along the outside diameter and flutes that remove chips from the cutting area and allow cooling fluids to enter. If heat is not reduced effectively, the tool’s cutting edges will dull and additional material buildup can occur. The number of flutes can range from two to eight. Two-flute designs offer the most efficient chip removal, but more flutes provide a smoother finish. The shank is the end of the tool held in place by a tool holder or machine. Center-cutting end mills can create three-dimensional shapes and profiles, and make plunge cuts similar to a drill bit. Non-center-cutting end mills are for applications such as peripheral milling and finishing, but cannot make plunge cuts. . manufactures drills, taps, end mills, and rotary tooling. The company, founded in 1981, is headquartered in South Korea and has a U.S. office in Vernon Hills, IL.. . . . .
industrial services nw ltd
Unit 3 Slaidburn Business Centre Slaidburn Crescent Southport Merseyside PR9 9YF United Kingdom 01704 228557 01704 507510